Cisco 7975G Software Manual page 127

Cisco Unified IP Phone Settings
Option
LLDP: PC Port
LLDP-MED: SW Port
LLDP Asset ID
Wireless Headset
Hookswitch Control
LLDP Power Priority
IP Addressing Mode
Description
Enables and disables Link Layer
Discovery Protocol (LLDP) on the PC
port. Use this setting to force the phone
to use a specific discovery protocol.
Settings include:
• Enabled (default)
• Disabled
Enables and disables Link Layer
Discovery Protocol Media Endpoint
Discovery (LLDP-MED) on the switch
port. Use this setting to force the phone
to use a specific discovery protocol,
which should match the protocol
supported by the switch. Settings include:
• Enabled (default)
• Disabled
Identifies the asset ID assigned to the
phone for inventory management.
Enables users to receive notifications of
incoming calls and answer or end calls
while they work in a wireless
environment.
Advertises the phone power priority to
the switch, which enables the switch to
appropriately provide power to the phone.
Settings include:
• Unknown (default)
• Low
• High
• Critical
Displays the IP addressing mode that is
available on the phone. IPv4 only, IPv6
only, or IPv4 and IPv6.
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Network Configuration Menu
To change
From Cisco Unified Communications
Manager Administration, choose
Device > Phone > Phone
Configuration.
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
From Cisco Unified Communications
Manager Administration, choose Device
> Device Settings > Common Device
Configuration.
Communications Manager 9.0 (SCCP and SIP)
107