New And Changed For Firmware Release 11.1(1); Phone Setup; Connect To The Network; Auto Provision Your Phone With Short Activation Code - Cisco 6800 Series User Manual

New and Changed for Firmware Release 11.1(1)

New and Changed for Firmware Release 11.1(1)
Feature
Call Center Support
Call Recording
Contrast Adjustment Enhancement
Power Save Support
Presence

Phone Setup

Your administrator sets up your phone and connects it to the network. If your phone is not set up and connected,
contact your administrator for instructions.
Cisco IP Phone 6841 Multiplatform Phones and Cisco IP Phone 6861 Multiplatform Phones do not support
Power over Ethernet (PoE). Connect the phone using the power adapter to power the phone.

Connect to the Network

You need to connect the phone to the telephone network.
• Wired connection—The phone is plugged into the network using an Ethernet cable.
• Wireless connection—The Cisco IP Phone 6861 Multiplatform Phones connect to a Wireless Access

Auto Provision Your Phone with Short Activation Code

After your phone boots up, you see a welcome screen where you can enter the activation code. If you don't
have the activation code, contact your administrator.
Before you begin
Your administrator provides your activation code:
Procedure
Step 1 Press pound (#), and enter your activation code in the field that is provided on the Welcome screen.
Cisco IP Phone 6800 Series Multiplatform Phones User Guide
16
Point using Wi-Fi. You need an SSID, security settings, username, and password to connect to the wireless
network. For more information, see
New or Changed Sections
Call Center Features, on page 80
Record a Call, on page 80
Adjust the Phone Screen Brightness or Contrast, on
page 133
Set up Power Save, on page 161
Instant Message and Presence Contacts, on page 105
Change Your Presence State, on page 107
Make a Call to an IM and Presence Contact, on page
106
Wi-Fi Settings, on page 134.
Your Phone