Using Host-Based EAP
Enabling PEAP
Follow the steps below to enable PEAP for this profile.
Step 1
For EAP Type, select Cisco PEAP or PEAP. If you select Cisco PEAP, go to
go to
Note
Step 2
Tap the Properties button. The PEAP Properties screen appears (see
Figure 5-8
Step 3
Make sure that the Validate server certificate check box is checked if server certificate validation is
required (recommended).
Step 4
If you want to specify the name of the server to connect to, check the Connect only if server name ends
in check box and enter the appropriate server name suffix in the field below.
Note
Note
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
5-22
Step
8.
PEAP appears as an EAP Type option on a PPC 2002 device if the Microsoft PEAP
supplicant (rather than the Cisco PEAP supplicant) was installed.
PEAP Properties Screen
If you enter a server name and the client adapter connects to a server that does not match the
name you entered, you are prompted to accept or cancel the connection during the authentication
process.
If you leave this field blank, the server name is not verified, and a connection is established as
long as the certificate is valid.
Chapter 5
Configuring the Client Adapter
Step
2. If you select PEAP,
Figure
5-8).
OL-1375-03