Table of Contents
Advertisement
To make the installed readers compatible with the new MPA2C3 panel the
addresses of the installed OSDP readers must be edited by adding 1 to their cur-
rent address.
Below the two possible procedures to edit the readers.
Option 1: Connect reader with highest address first.
First on OSDP1 (Readers for Door 1 and 3). If the panel is a 2-door panel, then the
steps 1 to 4 are discarded.
1. Connect Door 3, Reader OUT from MPA2C1 on MPA2C3 OSDP1 terminal and
2. Edit reader address and assign Door 3, Reader OUT
3. Connect Door 3, Reader IN from MPA2C1 on MPA2C3 OSDP1
4. terminal and let it come online, it will show up as Door 1, Reader OUT
5. Edit reader address and assign Door 3, Reader IN
6. Connect Door 1, Reader OUT from MPA2C1 on MPA2C3 OSDP1
7. terminal and let it come online, it will show up as Door 1, Reader IN
8. Edit reader address and assign Door 1, Reader OUT
9. Connect Door 1, Reader IN from MPA2C1 on MPA2C3 OSDP1
10. terminal and let it come online, it will show up as "New Reader with address 0"
11. Assign reader address as Door 1, Reader IN
Next on OSDP2 (Readers for Door 2 and 4). If the panel is a 2-door panel, then the
steps 9 to 12 are discarded.
1. Connect Door 4, Reader OUT from MPA2C1 on MPA2C3 OSDP2 terminal and
2. Edit reader address and assign Door 4, Reader OUT
3. Connect Door 4, Reader IN from MPA2C1 on MPA2C3 OSDP2
4. terminal and let it come online, it will show up as Door 2, Reader OUT
5. Edit reader address and assign Door 4, Reader IN
6. Connect Door 2, Reader OUT from MPA2C1 on MPA2C3 OSDP2
7. terminal and let it come online, it will show up as Door 2, Reader IN
8. Edit reader address and assign Door 2, Reader OUT
9. Connect Door 2, Reader IN from MPA2C1 on MPA2C3 OSDP2
66
let it come online, it will show up in the Web interface as Door 3, Reader IN
let it come online, it will show up in the Web interface as Door 4, Reader IN
MPA2C3 Installation Guide
Advertisement
Table of Contents
