Table of Contents
Advertisement
Main Board Rdr/Door 2 connector DOOR 2 / AUX2
Main Board Additional Input
connector
Table 2-3 Non- Supervised Input Terminal Blocks/RJ45
Board Configuration
Main Board Rdr/Door 1
connector
Main Board Rdr/Door 2
connector
Door contact (Drcnt) and Request to Exit (REX) for all doors may be configured for
Normally Open or Normally Closed contacts as supervised or non-supervised. All
inputs on the panel and eight additional inputs have default functions, but they
can be configured for general purpose inputs.
The following figure shows the typical wiring for the supervised and non-super-
vised inputs.
Figure 2-5
Standard 2.2K Ohm resistors will be used. MPA2S5 cable includes built-in 2K2
EOL (End of Line) resistors for door contact.
Note: Both resistors must have the same value.
28
GND, DrCnt2
GND, DrCnt AUX2
DOOR 2/ DOOR 4
GND, DrCnt2
GND, DrCnt4
INPUTS (AUX INPUTS)
GND, IN9 - IN16
Terminal Block
DOOR 1 / AUX1
GND, REX1
GND, REX AUX1
DOOR 1/ DOOR 3
GND, REX1
GND, REX3
DOOR 2 / AUX2
GND, REX2
GND, REX AUX2
DOOR 2/ DOOR 4
GND, REX2
GND, REX4
Typical Supervised and Non- Supervised Input Wiring Diagram
INPUT (AUX) IN9 - IN16
RJ45
DOOR 1
Pin 4: GND, Pin 1: REX1
AUX 1
Pin 4: GND, Pin 1: REX AUX1
DOOR 3
Pin 4: GND, Pin 1: REX3
DOOR 2
Pin 4: GND, Pin 1: REX2
AUX 2
Pin 4: GND, Pin 1: REX AUX2
DOOR 4
Pin 4: GND, Pin 1: REX4
/REX 3 - 4
/DrCnt3 - 4
DOOR 2
Pin4 GND; Pin2: DrCnt2
AUX2
Pin4 GND; Pin2 DrCnt AUX2
DOOR 4
Pin4 GND; Pin2: DrCnt4
N/A
MPA2C3 Installation Guide
Advertisement
Table of Contents
