CHAPTER
4
MOUNTING THE ENCLOSURE
Metal Enclosure Installation
Perform the following steps to install the panel in the Metal Enclosure:
Warning: Use a static strap whenever touching the panel to ensure protection from Electrostatic
Discharge (ESD).
Atention! Danger – risk of electric shock!
Before installation, TURN OFF the external circuit breaker which supplies power to
the system.
Before connecting the device to the power supply, verify that the output voltage is
within specifications of the power supply.
Do not apply power to the system until after the installation has been completed.
Personal injury or death could occur, and the equipment could be damaged beyond repair if this
precaution is not observed!
Warning Label:
Installing the Metal Lid (Optional)
1. Remove the grounding wire from the lid.
2. Remove the lid along the direction of the arrow. (Optional)
MPA2C3 Installation Guide
125