Cisco Room Kit EQX Installation Manual page 8

1.3. Fasten the beam to the wall
1. The distance from the floor to the lower edge of the wall
brackets are shown in the illustration.
Check the key holes to avoid placing the beam upside
down.
Up
D15514.01 | 2023 OCTOBER | Cisco Room Kit EQX Installation Guide 8
2. Make sure the beam is level, and fasten all the brackets
to the wall. You can use any of the horizontal slots in the
bracket.
The installer must provide screws and fasteners that
suites your type of wall.
×6
Copyright © 2023 Cisco Systems, Inc. All rights reserved.