Cisco Room Kit EQX Installation Manual page 31

10.3. Snap the camera onto the bracket
1. Observe the small hinges below the camera. They will
snap onto the bracket in step 4.
Hinges
2. Observe these fixing points under the camera bracket.
They will be used to secure the camera cables in step 5.
Fixing points
D15514.01 | 2023 OCTOBER | Cisco Room Kit EQX Installation Guide
3. Thread the cables down the hole by the camera bracket.
C2
C1
31
4. Click the camera hinges onto the bracket, without
pinching or disconnecting the cables.
C3
Make sure the camera sits firmly in
place by gently trying to pull it.
5. To avoid accidentally pulling out the camera cables,
secure them to the fixing points under the camera
bracket with the supplied plastic cable ties.
Allow enough cable length to be able to pull out the
camera if needed later.
Copyright © 2023 Cisco Systems, Inc. All rights reserved.