Cisco Room Kit EQX Installation Manual page 53

20.5. Move the screen to center
1. Push the screen gently (close to where the interface arms are attached), so
that the screen stays popped in.
2. Accurately measure the distance between the T-mark and the screen edge, B.
B
3. Push the screen gently, so that the screen pops out.
D15514.01 | 2023 OCTOBER | Cisco Room Kit EQX Installation Guide
4. Locate the screen bracket stopper closest to system center. It is fastened on top of the rail
with a screw (view from top, behind the screen).
Loosen the screw and slide the stopper so that the distance between the stopper
(Hex 4 mm)
and the closest interface arm is
The interface
arms
5. Tighten the screw to fasten the stopper in its new position.
6. Lift the screen slightly off the rail and re-position it as close to the stopper as possible.
7. Push the screen gently, so that the screen stays popped in.
53
1 mm less than the distance B that you just measured.
B-1 mm
Screen bracket
Copyright © 2023 Cisco Systems, Inc. All rights reserved.
stopper