Insert The Codec And Amplifier - Cisco Room Kit EQX Installation Manual

3. Insert the codec and amplifier

The codec and amplifier are placed in the center module, in
bays behind metal clamps.
amplifier
codec
Codec and amplifier
1x codec (Box: Codec)
1x amplifier (Box: Amplifier)
D15514.01 | 2023 OCTOBER | Cisco Room Kit EQX Installation Guide
3.1. Insert the codec
1. Loosen the four wing nuts that hold the right metal clamp
in place.
2. Slide the codec fully into the bay behind the clamp.
Connectors facing toward center; power socket up.
3. Slide the metal clamp to the right until it stops against the
codec edge; then tighten the four wing nuts to keep the
codec in place.
×4
14
3.2. Insert the amplifier
1. If the amplifiers has rack ears, remove them.
2. Loosen the four wing nuts that holds the left metal clamp
in place.
3. Slide the amplifier fully into the bay behind the clamp.
Connectors facing toward center; fan connectors up.
4. Slide the metal clamp to the left until it stops against the
amplifier edge; then tighten the four wing nuts to keep
the amplifier in place.
Wing
nuts
Wing
nuts
×4
Copyright © 2023 Cisco Systems, Inc. All rights reserved.
.
(Torx T10)