Cisco Room Kit EQX Installation Manual page 22

6.2. Insert the loudspeakers
The system has six loudspeakers; three on each side of the camera. The speakers are identical.
Repeat this procedure for all loudspeakers.
1. Connect the correct cable to the
loudspeaker.
The cables are marked with S1 to S6 -
counting from the left, see illustration.
D15514.01 | 2023 OCTOBER | Cisco Room Kit EQX Installation Guide
2. Enter the loudspeaker onto the pegs.
Check that the rubber gaskets stay firmly
on the pegs.
Make sure that no cables are touching
the loudspeakers. If they do, they may
cause rattling noise.
3. Fasten each loudspeaker with two
screws .
(M4x10, Torx T20)
S1
S2
S3
×6
12x
22
S4
S5
S6
Copyright © 2023 Cisco Systems, Inc. All rights reserved.