Cisco Room Kit EQX Installation Manual page 7

1.2. Add wall mount brackets to the beam
Read before you continue:
We provide 6 wall mount brackets to hold the
system.
The brackets can slide on the beam so that you can
place them where it suits best, for example where
there are studs in the wall.
You can use the holes that fit best to attach the
bracket to the wall.
The installer must provide screws and fasteners
that suites your type of wall.
The installer must decide the number of wall mount
brackets and where to place them to safely support
the system (weight up to 220 kg (485 lb) including
screens * ).
• Use at least 4 wall brackets.
• The distance from the outermost bracket to
the end of the beam must not exceed 400 mm
(15.7 in.) to ensure good weight distribution on
the beam.
Wall bracket dimensions:
7 mm (0.3 in)
10 mm (0.4 in)
27 mm (1.0 in)
87 mm (3.4 in)
* Maximum weight allowed per screen is 50 kg (110 lb).
D15514.01 | 2023 OCTOBER | Cisco Room Kit EQX Installation Guide
1. Enter one nut in each notch of the wall mount beam.
2x for each bracket
2. Fasten a wall mount bracket loosly to the nuts that you
just slid in with two screws
(M6x8, Hex 4 mm)
the screws.
2x for each bracket
7
3. Slide the bracket on the beam to its correct position.
4. When in the correct position, tighten the two screws.
; don't tighten
Repeat steps 1-4 above for all wall brackets.
Copyright © 2023 Cisco Systems, Inc. All rights reserved.