Table of Contents
Advertisement
The main cable routing areas
Behind the flap - from
the channels and through
the holes for the camera
and loudspeakers.
Keep
the cables away from the
loudspeakers to avoid
rattling noise. Use the
supplied velcro straps.
The bottom trays.
Keep
the cables away from
the bass to avoid rattling
noise. Use the supplied
velcro straps.
The channels between
the modules. Also the
channels on the sides can
be used, if convenient for
the socket outlet location
in your room.
Thread cables through the
holes where convenient.
In front of the codec
and amplifier clamps.
All cables for the codec/
amplifier comes from the
channels between the
modules.
Lead the cables out
through one of the holes,
across the clamp, and
then back again to the
connector panels. This is
important for strain relief.
When done, fasten the
cables with velcro.
A few cables also run
across from left to right
just below the clamps.
Keep the cables away from
the bass to avoid rattling
noise. Use the supplied
velcro straps.
D15514.01 | 2023 OCTOBER | Cisco Room Kit EQX Installation Guide
16
Copyright © 2023 Cisco Systems, Inc. All rights reserved.
Advertisement
Table of Contents
