Cisco Room Kit EQX Installation Manual page 56

21.3. Move the screen to center
1. Push the screen gently (close to where the interface arms are attached), so
that the screen stays popped in.
2. Accurately measure the distance, B, between the screens.
3. Push the screen gently, so that the screen pops out.
D15514.01 | 2023 OCTOBER | Cisco Room Kit EQX Installation Guide
4. Locate the screen bracket stopper closest to system center. It is fastened on top of the rail
with a screw (view from top, behind the screen).
Loosen the screw
and the closest interface arm is
B
5. Tighten the screw to fasten the stopper in its new position.
6. Lift the screen slightly off the rail and re-position it as close to the stopper as possible.
7. Push the screen gently, so that the screen stays popped in.
56
and slide the stopper so that the distance between the stopper
(Hex 4 mm)
2 mm less than the distance
B-2 mm
Screen bracket
stopper
Copyright © 2023 Cisco Systems, Inc. All rights reserved.
B that you just measured.
The interface
arms