No Snmp-Server Enable Traps Bcaststorm; Snmp-Server Enable Traps Linkmode; No Snmp-Server Enable Traps Linkmode; Snmp-Server Enable Traps Multiusers - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Default
Format
Mode

no snmp-server enable traps bcaststorm

This command disables the broadcast storm trap. When enabled, broadcast storm traps are sent
only if the broadcast storm recovery mode setting associated with the port is enabled .
Format
Mode

snmp-server enable traps linkmode

This command enables Link Up/Down traps for the entire switch. When enabled, link traps are
sent only if the Link Trap flag setting associated with the port is enabled (see 'snmp trap link-
status' command).
Default
Format
Mode

no snmp-server enable traps linkmode

This command disables Link Up/Down traps for the entire switch.
Format
Mode

snmp-server enable traps multiusers

This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is
sent when a user logs in to the terminal interface (EIA 232 or telnet) and there is an existing
terminal interface session.
Default
Format
Mode
Switching Commands
enabled
snmp-server enable traps bcaststorm
Global Config
no snmp-server enable traps bcaststorm
Global Config
enabled
snmp-server enable traps linkmode
Global Config
no snmp-server enable traps linkmode
Global Config
enabled
snmp-server enable traps multiusers
Global Config
202-10102-01, May 2005
8-31