User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
(IP Extended ACL)
Format
Mode
no access-list
This command deletes an IP ACL that is identified by the parameter <
the system
.
Format
Mode
ip access-group
This command attaches a specified IP ACL to one interface or to all interfaces.
An optional sequence number may be specified to indicate the order of this IP access list relative to
other IP access lists already assigned to this interface and direction. A lower number indicates
higher precedence order. If a sequence number is already in use for this interface and direction, the
specified access list replaces the currently attached IP access list using that sequence number. If
the sequence number is not specified for this command, a sequence number that is one greater than
the highest sequence number currently in use for this interface and direction is used.
Default
Format
Mode
Interface Config
no ip access-group
This command removes a specified IP ACL from an interface.
Default
Format
Mode
Interface Config
Quality of Service (QoS) Commands
access-list <100-199> {deny | permit} {every | {{icmp
| igmp | ip | tcp | udp | <number>} <srcip> <srcmask>
[{eq {<portkey> | <portvalue>} <dstip> <dstmask> [{eq
{<portkey>| <portvalue>} ] [precedence <precedence> |
tos <tos> <tosmask> | dscp <dscp>] [assign-queue
<queue-id>] [redirect <slot/port>]}}
Global Config
no access-list <accesslistnumber>
Global Config
none
ip access-group <accesslistnumber> in [sequence <1-
4294967295>]
Global Config
none
no ip access-group <accesslistnumber> in
202-10102-01, May 2005
from
accesslistnumber>
10-7