Show Service-Policy; Class Of Service (Cos) Commands; Classofservice Dot1P-Mapping - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

show service-policy

This command displays a summary of policy-oriented statistics information for all interfaces in the
specified direction.
Format
Mode
The following information is repeated for each interface and direction (only those interfaces configured with
an attached policy are shown):
Interface
Operational Status
Policy Name

Class of Service (CoS) Commands

This chapter provides a detailed explanation of the software QoS CoS commands. The following
commands are available in the software QOS module.
The commands are divided into these different groups:
• Configuration Commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.
• Show commands are used to display device settings, statistics and other information.
Note: The 'Interface Config' mode only affects a single interface, whereas the 'Global Config'
mode is applied to all interfaces.

classofservice dot1p-mapping

This command maps an 802.1p priority to an internal traffic class. The userpriority and
trafficclass can both range from 0-7, although the actual number of available traffic classes
depends on the platform. The 'no' form of this command is not supported.
Format
Modes
Quality of Service (QoS) Commands
show service-policy in
Privileged EXEC
Valid slot and port number separated by forward slashes.
The current operational status of this DiffServ service interface.
The name of the policy attached to the interface.
classofservice dot1p-mapping <userpriority> <traffic-
class>
Global Config
Interface Config
202-10102-01, May 2005
10-29