User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1),
SSH2 (2), or both SSH 1 and SSH 2 (1 and 2) can be set.
Default
Format
Mode
sshcon maxsessions
This command specifies the maximum number of SSH connection sessions that can be
established. A value of 0 indicates that no ssh connection can be established. The range is 0 to 5.
Default
Format
Mode
no sshcon maxsessions
This command sets the maximum number of allowed SSH connection sessions to the default
value.
Format
Mode
sshcon timeout
This command sets the SSH connection session timeout value, in minutes. A session is active as
long as the session has been idle for the value set. The time is a decimal value from 1 to 160.
Changing the timeout value for active sessions does not become effective until the session is re
accessed. Also, any keystroke activates the new timeout duration.
Default
Format
Mode
Security Commands
1 and 2
ip ssh protocol [1] [2]
Privileged EXEC
5
telnetcon maxsessions <0-5>
Privileged EXEC
no telnetcon maxsessions
Privileged EXEC
5
telnetcon timeout <1-160>
Privileged EXEC
202-10102-01, May 2005
9-23