User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
match source-address mac
This command adds to the specified class definition a match condition based on the source MAC
address of a packet. The <address
digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The <macmask
parameter is a layer 2 MAC address bit mask, which may not be contiguous, and is formatted as
six, two-digit hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc).
Default
Format
Mode
match srcip
This command adds to the specified class definition a match condition based on the source IP
address of a packet. The <ipaddr> parameter specifies an IP address. The <
specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits.
Default
Format
Mode
match srcl4port
This command adds to the specified class definition a match condition based on the source layer 4
port of a packet using a single keyword or numeric notation.
To specify the match condition as a single keyword notation, the value for <
supported port name keywords (listed below).
The currently supported <
Each of these translates into its equivalent port number, which is used as both the start and end of a
port range.
To specify the match condition as a numeric value, one layer 4 port number is required. The port
number is an integer from 0 to 65535.
Default
Format
Mode
Quality of Service (QoS) Commands
parameter is any layer 2 MAC address formatted as six, two-
>
none
match source-address mac <address> <macmask>
Class-Map Config
none
match srcip <ipaddr> <ipmask>
Class-Map Config
values are:
portkey>
domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www
None
match srcl4port {portkey | <0-65535>}
Class-Map Config
202-10102-01, May 2005
>
parameter
ipmask>
is one of the
portkey>
.
10-17