Mac Access-Group; No Mac Access-Group; Show Mac Access-Lists - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Note: The special command form {deny|permit} any any is used to match all Ethernet layer 2
packets, and is the equivalent of the IP access list "match every" rule.
Mode

mac access-group

This command attaches a specific MAC Access Control List (ACL) identified by <name> to an
interface in a given direction. The <name> parameter must be the name of an existing MAC ACL.
An optional sequence number may be specified to indicate the order of this mac access list relative
to other mac access lists already assigned to this interface and direction. A lower number indicates
higher precedence order. If a sequence number is already in use for this interface and direction, the
specified mac access list replaces the currently attached mac access list using that sequence
number. If the sequence number is not specified for this command, a sequence number that is one
greater than the highest sequence number currently in use for this interface and direction is used.
This command specified in 'Interface Config' mode only affects a single interface, whereas the
'Global Config' mode setting is applied to all interfaces. The 'Interface Config' mode command is
only available on platforms that support independent per-port class of service queue configuration.
Format
Modes

no mac access-group

This command removes a MAC ACL identified by <name> from the interface in a given direction.
Format
Modes

show mac access-lists

This command displays a MAC access list and all of the rules that are defined for the MAC ACL.
The [name] parameter is used to identify a specific MAC ACL to display.
Format
Mode
10-4
<0x0600-0xFFFF>] [vlan {eq <0-4095>} ] [cos <0-7>]
[assign-queue <queue-id>] [redirect <slot/port>]
Mac-Access-List Config
mac access-group <name> in [sequence <1-4294967295>]
Global Config
Interface Config
no mac access-list <name> in
Global Config
Interface Config
show mac access-lists [name]
Privileged EXEC
202-10102-01, May 2005
Quality of Service (QoS) Commands