No Radius Server Host; Radius Server Key - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
If the 'auth' token is used, the command configures the IP address to use to connect to a RADIUS
authentication server. Up to 3 servers can be configured per RADIUS client. If the maximum
number of configured servers is reached, the command will fail until one of the servers is removed
by executing the no form of the command. If the optional <port> parameter is used, the command
will configure the UDP port number to use to connect to the configured RADIUS server. In order
to configure the UDP port number, the IP address must match that of a previously configured
RADIUS authentication server. The port number must lie between 1 - 65535, with 1812 being the
default value.
If the 'acct' token is used, the command configures the IP address to use for the RADIUS
accounting server. Only a single accounting server can be configured. If an accounting server is
currently configured, it must be removed from the configuration using the no form of the
command before this command succeeds. If the optional <port> parameter is used, the command
will configure the UDP port to use to connect to the RADIUS accounting server. The IP address
specified must match that of a previously configured accounting server. If a port is already
configured for the accounting server then the new port will replace the previously configured
value. The port must be a value in the range 1 - 65535, with 1813 being the default value.
Format
Mode

no radius server host

This command is used to remove the configured RADIUS authentication server or the RADIUS
accounting server. If the 'auth' token is used, the previously configured RADIUS authentication
server is removed from the configuration. Similarly, if the 'acct' token is used, the previously
configured RADIUS accounting server is removed from the configuration. The <ipaddr>
parameter must match the IP address of the previously configured RADIUS authentication /
accounting server.
Format
Mode

radius server key

This command is used to configure the shared secret between the RADIUS client and the RADIUS
accounting / authentication server. Depending on whether the 'auth' or 'acct' token is used, the
shared secret is configured for the RADIUS authentication or RADIUS accounting server. The IP
address provided must match a previously configured server. When this command is executed, the
secret is prompted.
9-18
radius server host {auth | acct} <ipaddr> [<port>]
Global Config
no radius server host {auth | acct} <ipaddress>
Global Config
202-10102-01, May 2005
Security Commands