Show Service-Policy (Gsm7248 Only); Mac Access Control List (Acl) Commands (Gsm7248 Only); Mac Access-List Extended; Section 14.7 "Mac Access Control List (Acl) Commands (Gsm7248 Only) - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

14.6.7 show service-policy (GSM7248 only)

This command displays a summary of policy-oriented statistics information for all
interfaces in the specified direction.
Format
Mode
The following information is repeated for each interface and direction (only those
interfaces configured with an attached policy are shown):
Interface
Operational
Status
Policy Name
14.7 MAC Access Control List (ACL) Commands (GSM7248
only)
This section describes the commands you use to configure MAC ACL settings. MAC
ACLs ensure that only authorized users have access to specific resources and block any
unwarranted attempts to reach network resources.
The following rules apply to MAC ACLs:
• The maximum number of ACLs you create is 100, regardless of type.
• The system supports only Ethernet II frame types.
• The maximum number of rules per IP ACL is hardware dependent.
• If you configure an IP ACL on an interface, you cannot configure a MAC ACL on the
same interface.

14.7.1 mac access-list extended

This command creates a MAC Access Control List (ACL) identified by
consisting of classification fields defined for the Layer 2 header of an Ethernet frame. The
parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely
<name>
identifying the MAC access list.
Quality of Service (QoS) Commands
show service-policy in
Privileged EXEC
Valid slot and port number separated by forward slashes.
The current operational status of this DiffServ service inter-
face.
The name of the policy attached to the interface.
v1.0, February 2007
,
<name>
14-31