Secure Shell (Ssh) Command; Ip Ssh; Ip Ssh Protocol; Section 3.5 "Secure Shell (Ssh) Command - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

3.5 Secure Shell (SSH) Command

This section describes the commands you use to configure SSH access to the switch. Use
SSH to access the switch from a remote management host.
Note: The system allows a maximum of 5 SSH sessions.

3.5.1 ip ssh

This command is used to enable SSH.
Default
Format
Mode
3.5.1.1 no ip ssh
This command is used to disable SSH.
Format
Mode

3.5.2 ip ssh protocol

This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1
(1), SSH2 (2), or both SSH 1 and SSH 2 (1 and 2) can be set.
Default
Format
Mode
Administrative Access Commands
disabled
ip ssh
Privileged EXEC
no ip ssh
Privileged EXEC
1 and 2
ip ssh protocol [1] [2]
Privileged EXEC
v1.0, February 2007
3-15