Messages - GE Healthcare B30 User's Reference Manual

B30 Patient Monitor

Messages

Table 10-1
Message
Air leakage
Alarms acknowledged (from
Central)
Alarm setup changed from
Central
Alarms silenced from Central Alarms have been silenced using the
Apnea
Apnea deactivated
Artifacts
Asystole
Battery low
Brady
Calibr. error
Check D-fend
10-2
Messages
Explanation
Air leak in cuff or hose.
Silenced alarms remain silent. New
alarms will have an audible sound.
(Can be done using the Central).
Alarm limits or arrhythmia alarm
priorities have been changed using
the Central.
Central.
No breath detected for 20 seconds.
The case has just been started or the
measurement has just been activated,
and apnea alarm is not active yet. It
will activate after 5 breaths.
Some artifacts (muscle activity, eye
movements etc.). may disturb certain
measurements.
No QRS detected in ECG.
About 20 minutes of battery operation
time left.
HR is equal to or below the lower
alarm limit.
Unsuccessful gas calibration.
The water trap is not attached.
What to do
•
NIBP: Check all connections and
test tightness using Venous Stasis.
•
If required, turn on the alarms
Alarms Setup
through
ON/OFF – Activate Alarms.
•
Check the alarm limits and the
arrhythmia alarm priorities; see
"Alarms" and "Troubleshooting".
•
If required, turn on the alarms
Alarms Setup
through
ON/OFF – Activate Alarms.
•
Check the patient status.
•
Check the ventilator and breathing
circuit.
•
The message will disappear after
the monitor detects three breaths.
•
Calm the patient since patient
movements, shivering, deep
breathing, arrhythmia or irregular
beats may cause some
measurements to fail.
•
If applicable, start a new
measurement.
•
Check the patient status.
•
Check the electrodes.
•
Replace the battery or connect the
monitor to power outlet.
•
Check the patient status.
•
Perform a new calibration.
•
Check that the water trap is
properly attached to the module. If
the problem persists, contact
authorized service personnel.
– Audio
– Audio