Changing The Normal Screen Layout - GE Healthcare B30 User's Reference Manual

B30 Patient Monitor

Changing the Normal Screen layout

At startup, the screen is arranged according to the startup mode definitions. Parameters that
are not used are not displayed and no space is reserved for them. You can decide which
waveforms and numerical information are displayed, and where on the screen they are
arranged. You can do this for the duration of monitoring or save the changes in the user mode.
To make the changes permanent, save them in the user mode through
Install/Service - Save Modes.
Digit Field 1
Figure 5-1
To change the Normal Screen page:
1. Press the
2. Select Screen Setup.
3. Select Waveform Fields, Digit Fiel
Monitor
Setup
NOTE: Choosing the same parameter in the waveform and digit field makes the
previously chosen field disappear.
5-8
Alarms message field
Real-time
Menus
waveforms
or trends
Digit Field 2
Display fields
Monitor Setup
key.
Waveform
digits
Digit Field 3
Digit Field 4
ds,split S
creen or Minitrend Length.
Monitor Setup
-