Table of Contents
Advertisement
Figure 74. Installing filler bracket for butterfly riser
Next steps
1.
Replace expansion card into the expansion card
2. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and push the expansion
card latch.
NOTE:
You must install a filler bracket over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust out of the system and aid in proper
cooling and airflow inside the system.
Installing expansion card into the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5.
Open the drive
bays, remove
6. Remove the
power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals
8.
Remove the system
cover.
9.
Remove the air
shroud.
10.
Remove the expansion card riser from the
11. When removing a card from low profile, full height X1, or butterfly riser, ensure that the PCIe card holder latch is closed.
12. When installing a card into low profile, full height X1, or butterfly riser, open the PCIe card holder latch.
13. If installing a new expansion card, unpack it and prepare the card for installation.
NOTE:
For instructions, see the documentation accompanying the card.
Steps
1. Open the expansion card retention latch.
riser.
Safety
Instructions.
all
drives, and then
close the drive
units.
.
system.
bays.
Installing and removing system components
91
Advertisement
Table of Contents
