Table of Contents
Advertisement
Figure 45. Removing bay 2 backplane brackets
Next steps
Replace the drive bay 2 backplane
Installing the drive bay 2 backplane brackets
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. If installed,
remove the front
6.
Open the drive
bays, remove
7. Remove the
power supply
8. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
9.
Open the drive bays
Steps
1. Align the backplane brackets with the slots at the bay base in drive bay 2.
2. Slide the brackets to the right until the brackets are firmly seated and lock into the place.
3. Using a Phillips #1 screwdriver, replace the screws on top of the drive bay 2.
64
Installing and removing system components
brackets.
Safety
Instructions.
bezel.
all
drives, and then
close the drive
units.
bays.
Advertisement
Table of Contents
