Table of Contents
Advertisement
Figure 122. Removing the right control panel
Next steps
Replace the right control
panel.
Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
4.
Open the drive
bays, remove
5. Remove the
power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
7.
Remove the system
cover.
8.
Remove the air
shroud.
9.
Remove the internal PERC
Steps
1. Route the control panel cable through the right control panel cable clips and push the cable connector through the side of bay 2.
132
Installing and removing system components
Safety
Instructions.
all
drives, and then
close the drive
units.
card.
bays.
Advertisement
Table of Contents
