Table of Contents
Advertisement
Figure 65. Installing the heat sink onto the processor
Next steps
1.
Install the processor and
2. If removed,
install the
risers.
3.
4.
Install the air
shroud.
5. Install the
system
cover.
6. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.
7.
Open the drive
bays, install
8. Install the
power supply
9. Follow the procedure listed in
Installing a processor and heat sink module
Prerequisites
CAUTION:
Never remove the heat sink from a processor unless you intend to replace the processor. The heat sink is
necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5.
Open the drive
bays, remove
6. Remove the
power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals
8.
Remove the system
cover.
84
Installing and removing system components
heatsink.
all
drives, and then
close the drive
units.
After working inside your
Safety
Instructions.
all
drives, and then
close the drive
units.
.
bays.
system.
bays.
Advertisement
Table of Contents
