Dell E56S Series Installation And Service Manual page 105

Figure 94. Installing optional IDSDM/vFlash card
Next steps
1. Install the MicroSD cards.
NOTE: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during
removal.
2. Install the air shroud.
3. Install the system cover.
4. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.
5. Open the drive bays, install
6. Install the power supply
7. Follow the procedure listed in
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
7. Remove the system cover.
8. Remove the air shroud.
9. Remove the IDSDM or vFlash
Steps
1. Locate the MicroSD card slot on the IDSDM/vFlash module, and press the card to partially release it from the slot.
2. Hold the MicroSD card and remove it from the slot.
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
all drives, and then close the drive
units.
After working inside your
Safety Instructions.
all drives, and then close the drive
units.
module.
bays.
system.
bays.
Installing and removing system components 105