Table of Contents
Advertisement
Figure 49. 12 x 3.5-inch drive backplane
1. Power connector (J_BP_PWR1)
3. SAS/SATA cable connector (BP SAS A2)
5. SAS/SATA cable connector (BP SAS B0)
7. Intrusion switch cable connector
Removing the drive bay 1 backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, remove the drives from the system before removing the
backplane.
CAUTION:
Note the number of each drive and temporarily label them before you remove the drive so that you can
replace them in the same location.
NOTE:
Ensure that the drive bay is fully open to access the backplane.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If installed,
remove the front
4.
Remove all the drives
from the drive slots from bay 1.
5.
Open the drive
bays.
6.
Remove the drive bay 1
7.
Remove the bay intrusion
8. Disconnect all the cables from the backplane.
Steps
1. Using Phillips #2 screwdriver, remove all the screws securing the backplane.
Figure 50. Removing the screws from the backplane
2. Hold the backplane by the edges and remove it from the bay.
68
Installing and removing system components
Safety
Instructions.
Before working inside your
bezel.
bracket.
switch.
2. SAS/SATA cable connector (BP SAS A1)
4. Signal connector (J_BP_SIG1)
6. SAS/SATA cable connector(BP SAS A0)
system.
Advertisement
Table of Contents
