Dell E56S Series Installation And Service Manual page 81

3. Push the retaining clips on the processor bracket to release the bracket from the heat sink.
Figure 61. Loosening the processor bracket
4. Lift the processor bracket away from the heat sink, and place the processor connector side down on the processor tray.
5. Flex the outer edges of the bracket to release the bracket from the processor.
NOTE: Ensure that the processor bracket is placed in the tray after you remove it from the heat sink.
Figure 62. Removing the processor bracket
Next steps
Replace the processor into a processor and heat sink
Installing the processor
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
module.
Safety Instructions.
all drives, and then close the drive bays.
Installing and removing system components 81