Table of Contents
Advertisement
NOTE:
When a replacement hot swappable drive is installed while the system is powered on, the drive automatically
begins to rebuild. Ensure that the replacement drive is blank. Any data on the replacement drive is immediately lost once
the drive is installed.
1. Follow the safety guidelines listed in
2. If installed,
remove the drive
NOTE:
To avoid the metal stops from bending in the drive cage in the drive bays, populate the drives in a bottom to top
order.
Steps
1. Press the release button on the front of the drive carrier to open the release handle.
2. Insert and slide the drive carrier into the drive slot.
3. Close the drive carrier release handle until it clicks in place.
Figure 37. Installing a drive carrier
Next steps
If removed,
install the front
Removing the drive from the drive carrier
Prerequisites
CAUTION:
Mixing drives from previous generations of XC systems is not supported.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2. Lift the drive out of the drive carrier.
58
Installing and removing system components
Safety
Instructions.
blank.
bezel.
Advertisement
Table of Contents
