Table of Contents
Advertisement
Figure 95. Removing the MicroSD card
Next steps
Replace the MicrosSD
card.
Installing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5.
Open the drive
bays, remove
6. Remove the
power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
8.
Remove the system
cover.
9.
Remove the air
shroud.
10.
Remove the IDSDM or vFlash
NOTE:
To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked
on the cards during removal.
Steps
1. Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot.
NOTE:
The slot is designed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
106
Installing and removing system components
Safety
Instructions.
all
drives, and then
close the drive
units.
module.
bays.
Advertisement
Table of Contents
