Dell E56S Series Installation And Service Manual page 104

Figure 93. Removing the optional IDSDM or vFlash card
Next steps
NOTE: If you are replacing the IDSDM or vFlash module, remove the microSD cards.
Replace optional IDSDM/vFlash
Installing IDSDM/vFlash module
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals
8. Remove the system cover.
9. Remove the air shroud.
Steps
Insert the IDSDM/vFlash module into the system board connector.
104 Installing and removing system components
module.
Safety Instructions.
all drives, and then close the drive
units.
.
bays.