Dell E56S Series Installation And Service Manual page 70

Figure 52. Installing bay 1 backplane
Next steps
1. Install the bay intrusion
2. Connect all the cables to the backplane.
3. Install the drive bay 1 bracket.
4. Install the drives back into their original locations.
5. Close the drive bays.
6. If removed, install the front
7. Follow the procedure listed in
Removing the drive bay 2 backplane
Prerequisites
CAUTION: Note the number of each drive and temporarily label them before you remove the drive so that you can
replace them in the same location.
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
7. Open the drive bays.
NOTE: Ensure that the drive bay is fully open to access the backplane.
8. Remove the drive bay 2 backplane brackets.
9. Disconnect all the cables from the backplane.
Steps
1. Using Phillips #2 screwdriver, remove all the screws securing the backplane.
70 Installing and removing system components
switch.
bezel.
After working inside your
Safety Instructions.
all drives, and then close the drive
units.
system.
bays.