Dell E56S Series Installation And Service Manual page 46

Figure 23. Installing internal PERC riser
Next steps
1. Connect the cables to the backplane and then route the cables to the cable guiding latch and close the latch.
2.
3. Install the air shroud.
4. Install the system cover.
5. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.
6. Open the drive bays, install
7. Install the power supply
8. Follow the procedure listed in
Removing the HBA 330 from the internal PERC riser
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
7. Remove the system cover.
8. Remove the air shroud.
9. Remove the internal PERC
Steps
Pull the HBA 330 out of the connector on the internal PERC riser.
46 Installing and removing system components
all drives, and then close the drive
units.
After working inside your
Safety Instructions.
all drives, and then close the drive
units.
riser.
bays.
system.
bays.