Dell E56S Series Installation And Service Manual page 47

Figure 24. Removing the HBA 330 from the internal PERC riser
Next steps
Replace the PERC card into the PERC riser
Installing PERC card into the internal PERC riser
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
8. Remove the system cover.
9. Remove the air shroud.
10. Remove the internal PERC
Steps
Align the PERC card to the guiding pins on the internal PERC riser and push the card in.
Safety Instructions.
all drives, and then close the drive
units.
riser.
bays.
Installing and removing system components 47