Table of Contents
Advertisement
Steps
1. Align the backplane bracket with the two slots at the bay base in drive bay 1.
2. Slide the bracket to the left until it is firmly seated and locks into place.
3. Using a Phillips #1 screwdriver, tighten the screws on top of the drive bay to secure the bracket.
Figure 44. Installing bay 1 backplane bracket
Next steps
1.
Install all the
drives.
2.
Close the drive
bays.
3. If removed,
install the front
4. Follow the procedure listed in
Removing the drive bay 2 backplane brackets
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. If installed,
remove the front
5.
Open the drive
bays, remove
6. Remove the
power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals
8.
Open the drive
bays.
Steps
1. Using a Phillips #1 screwdriver, remove the screws on the top of the drive bay 2, securing the backplane brackets.
2. Disconnect the cables of the cable chain assembly connected to the backplane.
3. Slide the brackets to the right to disengage them from the slots on the bay base in drive bay 2.
4. Lift the right bracket away from the system and move the left bracket away from the drive bay.
bezel.
After working inside your
Safety
instructions.
bezel.
all
drives, and then
close the drive
units.
.
system.
bays.
Installing and removing system components
63
Advertisement
Table of Contents
