Table of Contents
Advertisement
Figure 18. Removing air shroud
Next steps
Replace the air
shroud.
Installing the air shroud
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5.
Open the drive
bays, remove
6. Remove the
power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
8.
Remove the system
cover.
9. If installed,
remove the butterfly
Steps
1. Align the slots on the air shroud with the guide pin on the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Lower the air shroud into the system until it is firmly seated.
42
Installing and removing system components
Safety
Instructions.
all
drives, and then
close the drive
units.
riser.
bays.
Advertisement
Table of Contents
