Table of Contents
Advertisement
Figure 112. Removing screws for cable chain base bracket and cable chain side cover
6. Slide drive bay 2 towards the rear of the system until the screws for the left and right white plastic rail stops are visible and remove
them.
7. Disconnect the left control panel cable from the system board and release it from the cable chain base bracket.
Figure 113. Removing the left and right rail white plastic rail stops
8. Remove the screws connecting the cable chain rail to the chassis.
9. Extend the drive bays all the way out of the bay area, until there is a gap to remove the cable chain rail.
10. Lift the cable chain assembly out of the system.
124
Installing and removing system components
Advertisement
Table of Contents
