Table of Contents
Advertisement
Figure 114. Removing the cable chain assembly from the system
Next steps
Replace the cable chain
assembly.
Installing the cable chain assembly
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5.
Open the drive
bays, remove
6. Remove the
power supply
7. If installed,
remove the front
8. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
9.
Remove the system
cover.
10. Remove the following:
a.
Drive bay 1 backplane
b.
Drive bay 2 backplane
c.
Air
shroud.
d.
Intrusion
switch.
e.
Internal PERC
riser.
f.
Memory modules for processor
g. PIB.
11. Disconnect all cables connected to the cable chain assembly from the backplanes and the system board.
Steps
1. Place the cable chain assembly in the system and route the left control panel cable through the cable chain base bracket.
Safety
Instructions.
all
drives, and then
close the drive
units.
bezel.
bracket.
bracket.
1.
bays.
Installing and removing system components
125
Advertisement
Table of Contents
