Table of Contents
Advertisement
Figure 25. Installing the PERC card into internal PERC riser
Next steps
1.
Install the internal PERC riser
2.
Install the air
shroud.
3. Install the
system
cover.
4. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.
5.
Open the drive
bays, install
6. Install the
power supply
7. Follow the procedure listed in
Cooling fans
Removing the cooling fan
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4.
Open the drive
bays, remove
5. Remove the
power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
7.
Remove the system
cover.
8.
Remove the air
shroud.
9.
Remove the internal PERC
10. Move the cables out of the way to access the cooling fan cable connector on the system board.
48
Installing and removing system components
all
drives, and then
close the drive
units.
After working inside your
all
drives, and then
close the drive
units.
riser.
bays.
system.
bays.
Advertisement
Table of Contents
