Table of Contents
Advertisement
Figure 51. Removing bay 1 backplane
Next steps
Replace the drive bay 1
backplane.
Installing the drive bay 1 backplane
Prerequisites
Follow the safety guidelines listed in
NOTE:
The procedure to install the backplane is similar for all backplane configurations.
1. Follow the procedure listed in
2. If installed,
remove the front
3.
Remove all the drives
from the drive slots from bay 1.
4.
Open the drive
bays.
5.
Remove the drive bay 1
6.
Remove the bay intrusion
7. Disconnect all the cables from the backplane.
Steps
1. Align the backplane to the guiding pins on the bay.
2. Using Phillips #2 screwdriver, tighten all the screws to secure the backplane.
Safety
Instructions.
Before working inside your
bezel.
bracket.
switch.
system.
Installing and removing system components
69
Advertisement
Table of Contents
