Table of Contents
Advertisement
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5.
Open the drive
bays, remove
6. Remove the
power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
8.
Remove the system
cover.
9.
Remove the air
shroud.
10.
Remove the internal PERC
Steps
1. Align and slide intrusion switch into the slot in the system.
Figure 31. Installing the intrusion switch
2. Connect the intrusion switch cable to the connector on the system board.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Next steps
1.
Install the internal PERC riser
2.
Install the air
shroud.
3. Install the
system
cover.
4. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.
5.
Open the drive
bays, install
6. Install the
power supply
7. Follow the procedure listed in
Safety
Instructions.
all
drives, and then
close the drive
units.
riser.
all
drives, and then
close the drive
units.
After working inside your
bays.
bays.
system.
Installing and removing system components
53
Advertisement
Table of Contents
