Shift Solenoid Valve Test - Honda Accord 2008 Manual

07/11/02 09:18:06 61TA0000_140_0224
Automatic Transmission

Shift Solenoid Valve Test

1. Connect the HDS to the DLC (A) located under the
driver's side of the dashboard.
＊０１
2. Turn the ignition switch to ON (II). Make sure the
HDS communicates with the PCM. If it does not, go
to the DLC circuit troubleshooting (see page
11-208).
3. Select Shift Solenoid Valves A, B, C, D, and E in the
Miscellaneous Test Menu on the HDS.
4. Check that shift solenoid valves A, B, C, D, and E
operate with the HDS. A clicking sound should be
heard.
• If a clicking sound is heard, the valves are OK.
The test is complete, disconnect the HDS.
• If no clicking sound is heard, go to step 5.
5. Raise the vehicle on a lift, or apply the parking
brake, block the rear wheels, and raise the front of
the vehicle. Make sure it is securely supported.
6. Remove the splash shield.
14-222
A
7. Disconnect the shift solenoid wire harness
connector.
Terminal side of male terminals
8. Measure the resistance:
• No. 1 terminal: Shift solenoid valve C
• No. 2 terminal: Shift solenoid valve B
• No. 3 terminal: Shift solenoid valve E
• No. 5 terminal: Shift solenoid valve A
• No. 8 terminal: Shift solenoid valve D
−
Standard: 12 25
• If the resistance is within the standard, go to step
9.
• If the resistance is out of standard, go to step 10.
9. Connect a jumper wire from the battery positive
terminal to each shift solenoid wire harness
connector terminal individually. A clicking sound
should be heard.
• If a clicking sound is heard, the valves are OK.
The test is complete, reconnect the connector.
• If no clicking sound is heard, go to step 10.
ＴＡ０８ＡＡ１Ｅ１０４１０６５４８０１ＦＥＡＴ４０
＊０２