Clutch Master Cylinder Replacement - Honda Accord 2008 Manual

07/11/02 09:15:14 61TA0000_120_0011

Clutch Master Cylinder Replacement

NOTE:
• Use fender covers to avoid damaging painted
surfaces.
• Do not spill brake fluid on the vehicle; it may damage
the paint or plastic. If brake fluid does contact the
paint or plastic, wash it off immediately with water.
1. Remove and discard the brake fluid from the clutch
master cylinder reservoir with a syringe or other
suitable device.
2. Pry out the lock pin (A), and pull the pedal pin (B)
out of the yoke. Remove the master cylinder
mounting nuts (C).
＊０１
B
C
3. Remove the reservoir mounting bolt (A) and the
retaining clip (B) then disconnect the clutch line (C)
from the clutch master cylinder (D), and remove the
O-ring (E). Plug or wrap the end of the reservoir
hose and clutch line with a clean shop towel to
prevent brake fluid from coming out.
D
C
A
C
4. Remove the master cylinder (A) and clutch master
cylinder seal (B).
B
ＴＡ０８ＡＥＡＥ３４１１６３１７０３１ＫＢＡＴ００
A
B
E
A
(cont'd)
12-9
＊０２
＊０３