Transmission Installation - Honda Accord 2008 Manual

07/11/02 09:24:01 61TA0000_130_0016
Manual Transmission

Transmission Installation

Special Tools Required
• Engine support hanger, A & Reds AAR-T1256
• Engine hanger/adapter VSB02C000015
• Subframe adapter VSB02C000016
• Frame positioning guide pin 070AG-SJAA10S
These special tools are available through the Honda
Tool and Equipment Program 888-424-6857.
NOTE: Use fender covers to avoid damaging painted
surfaces.
1. Make sure the two 14 x 20 mm dowel pins (A) are
installed in the clutch housing.
＊０１
A
C
2. Apply super high temp urea grease (P/N
08798-9002) to the release fork (B) and the release
bearing (C). Install the release fork, the release
bearing and the boot (D).
NOTE: Using any other type of grease may cause
inconsistent clutch operation and/or excessive
wear to the release fork, release bearing, and
transmission case.
3. Place the transmission on the transmission jack,
and raise it to engine level.
13-16
(P/N 08798-9002)
− −
1.0 1.6 g (0.04 0.06 oz)
A
(P/N 08798-9002)
0.4 1.0 g −
(0.01 0.04 oz) −
4. Install the lower transmission mounting bolts.
Front side
12 x 1.25 mm
64 N·m
(6.5 kgf·m,
47 lbf·ft)
Rear side
B
D
ＴＡ０８ＡＥＡＥ３４１５０１０００００ＫＣＡＴ００
＊０２
12 x 1.25 mm
64 N·m
(6.5 kgf·m,
47 lbf·ft)
＊０３
12 x 1.25 mm
64 N·m
(6.5 kgf·m,
47 lbf·ft)