Honda Accord 2008 Manual page 954

07/11/02 08:48:07 61TA0000_140_0111
11. Connect PCM connector C (49P).
12. Disconnect the output shaft (countershaft) speed
sensor connector.
13. Turn the ignition switch to ON (II).
14. Measure the voltage between output shaft
(countershaft) speed sensor connector terminal
No. 1 and body ground.
＊０２
Is there about 5 V ?
YES
NO −
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR CONNECTOR
VCC1 (YEL/RED)
Wire side of female terminals
−
Go to step 18.
Go to step 15.
15. Turn the ignition switch to LOCK (0).
16. Disconnect PCM connector C (49P).
17. Check for continuity between PCM connector
terminal C13 and output shaft (countershaft) speed
sensor connector terminal No. 1.
OUTPUT SHAFT PCM CONNECTOR C (49P)
(COUNTERSHAFT)
SPEED SENSOR
CONNECTOR
VCC1
(YEL/RED)
Wire side of
female terminals
Is there continuity?
YES − Go to step 18.
−
NO Repair open in the wire between PCM
connector terminal C13 and the output shaft
(countershaft) speed sensor, then go to step 32.
VCC1 (YEL/RED)
Terminal side of
female terminals
(cont'd)
14-109
＊０３