Road Test - Honda Accord 2008 Manual

07/11/02 09:17:36 61TA0000_140_0217

Road Test

1. Start the engine, and warm it up to normal
operating temperature (the radiator fan comes on).
2. Apply the parking brake, and block both rear
wheels. Start the engine, then to D while pressing
the brake pedal. Press the accelerator pedal, and
release it suddenly. The engine should not stall.
3. Repeat step 2 in all shift lever positions.
4. Connect the HDS to the DLC (A) located under the
driver's side of the dashboard, and go to the A/T
Data list.
＊０１
5. Turn the ignition switch to ON (II). Make sure the
HDS communicates with the PCM. If it does not, go
to the DLC circuit troubleshooting (see page
11-208).
A
6. Prepare the HDS to take a HIGH SPEED SNAPSHOT
(refer to the HDS user's guide for more details if
needed):
• Select the High Speed icon.
• Select these parameters:
– Vehicle Speed
– Output Shaft (Countershaft) Speed
– Input Shaft (Mainshaft) Speed (rpm)
– Engine Speed
– Relative TP Sensor
– APP Sensor A (V)
– ATF Temp Sensor (V)
– Battery Voltage
– Shift Control
– Brake Switch
• Set the Trigger Type to Parameter.
• Adjust the Parameter setting to APP Sensor A
above 1.2 V.
• Set the recording time to 60 seconds.
−
• Set the trigger point to
7. Find a suitable level road. When you are ready to
begin the test, press OK on the HDS.
8. Monitor the HDS and accelerate quickly until the
APP Sensor A reads 1.3 V. Maintain a steady
throttle until the transmission shifts to 5th gear,
then slow the vehicle and come to a stop.
9. Save the snapshot if the entire event was recorded
or increase the recording time setting as necessary
and repeat step 8.
10. Adjust the parameter setting to 2.4 V. Test-drive the
vehicle again. While monitoring the HDS,
accelerate quickly until the APP Sensor A reads
2.5 V. Maintain a steady throttle until the
transmission shifts to 5th gear (or reasonable
speed), then slow the vehicle and come to a stop.
11. Save the snapshot if the entire event was recorded
or increase the recording time setting as necessary
and repeat step 10.
12. Accelerate quickly until the accelerator pedal is to
the floor. Maintain a steady pedal until the
transmission shifts to 3rd gear, then slow to a stop,
and save the snapshot.
ＴＡ０８ＡＥＢＥ１０４００００００００ＦＥＡＴ００
30 seconds.
(cont'd)
14-215